salmson LRE Instructions De Montage Et De Mise En Service page 49

ENGLISH
LCdisplay
12
13
Setting the range of values for the set pressure value (step 3)
This menu comes after the above menu
The setting – V or mA – is taken from the previous step.
The upper limit of the range of values is 10 V or 20 mA.
The value for the lower limit blinks.
Setting the lower limit
[0 (-10V) / 2 (-10V) or 0 (-20 mA) / 4 (-20mA)]:
Press button. The new setting blinks.
Press acknowledge button to store the new setting.
X
Menu is displayed.
13
Activating / deactivating the fault-tolerant error matrix.
Switching between heating / air-conditioning mode.
Setting the mode
Press button. The new setting blinks.
Press acknowledge button to store the new setting.
X X X
Menu , or 2 is displayed.
14 15
The mode selection determines the reaction in the case of a fault con-
dition.
43
Setting
X
.
11