Mechanical Cooking Programmer; Switching On The First Time; Suggestions - Franke MARIS FREE MA 82 M /F Série Manuel D'installation Et D'utilisation

EN

Mechanical cooking programmer

(Fig. 1)
End of cooking timer knob (B)
The end of cooking timer is a practical device that
turns the oven off automatically at a set time in an
interval of 1 to 120 minutes.
9 To use the end of cooking timer, the ringer must
be wound up by turning the knob (B) almost
one full turn clockwise; then, turning back,
set the required time by aligning the number
corresponding to the minutes with the fixed
reference on the front panel.
At the end of the set time, the ringer sounds
„ „
and the oven is automatically switched off.
A Note: The oven stays hot
at around the set cooking
temperature for a long time
after it has been switched
off; therefore to avoid
overcooking or burning the
food, it is advisable to remove
it from the oven.
Note: To use the oven in
manual mode, i.e. without using the end of cooking
timer, align the knob (B) pointer with the fixed symbol
on the front panel. When the oven is turned off,
the end of cooking programmer can be used as a
normal timer.

Switching on the first time

When using the oven for the first time, operate it
X X
empty with the temperature knob set to maximum
for at least 40 minutes, and airing the room.
The odour noticed during this operation is
„ „
due to the evaporation of substances used to
protect the oven during the period between
manufacture and installation.
After the 40 minutes, the oven stops
„ „
automatically and will be ready for use after
cooling down the oven.
MA 82 M _/F

Suggestions

Z X
Z X
9 place them above the grills or drip-trays provided,
Z X
Z X
B
Z X
Z X
Note: Before switching the oven on, read the timer
instructions (on this page).
– 10 –
For successful cooking, never place your dishes in
the oven when it is cold; wait until it has reached
the set temperature.
During cooking, never place pots or containers
directly on the oven floor;
on one of the 5 shelves available;
failure to do so could damage the oven
„ „
enamel.
Never cover the walls of the oven with aluminium
foil, especially in the lower part of the cooking
compartment.
Any repairs must be carried out by specialised,
licensed personnel. Contact our nearest service
centre and demand only original spare parts.
D
Your Franke oven uses a special enamel which
is easy to keep clean, however it is advisable to
clean it frequently to avoid baking on grime and
previous cooking residues.
Any self-cleaning panels (if provided) can be
cleaned with soap and water (see cleaning
instructions).
C