Digital Cooking Programmer - Franke SMART PLUS SMP 86 M F Série Manuel D'installation Et D'utilisation

EN

Digital cooking programmer

(Fig. 1)
It enables oven programming
in the following modes:
– delayed start of cooking
with set duration,
– immediate start of
cooking with set duration;
– timer.
Setting the digital clock
When the appliance has been connected to the
mains or after a power failure the display will
flash on: „0.00".
Press the + and - buttons together for a few
X X
seconds. The time of day can be adjusted with the
+ and - buttons, while the dot between the hours
and minutes flashes.
If the time setting mode is selected when an
„ „
automatic programme is active, the automatic
programme is cancelled.
Possible time adjustments can be made by
repeating the steps described above.
Acoustic signal frequency modification
The frequency of the acoustic signal can be changed
if a cooking cycle is not programmed (therefore the
display shows the time of day).
Press the + and - buttons (from the time
X X
modification menu) together.
Press Mode or Set to select the menu for
X X
modifying the acoustic signal frequency.
The acoustic signal frequency can be modified
X X
by repeatedly pressing the Mode or Set button;
„ton1", „ton2", „ton3" will appear on the display.
Manual oven operation
Once the time has been set, the programmer
automatically switches to manual mode.
Starting delayed cooking with set duration
When the time of the day is displayed, press the
X X
Mode or Set button twice to set a duration.
Then press it again to set the end of cooking time.
X X
Set the required time with the + and - buttons.
X X
During duration or end time adjustment mode
„ „
selection, the Auto symbol remains lit.
Once a programme duration is set, the end
„ „
time cannot be decreased.
Likewise, the duration of a programme cannot
„ „
be prolonged once the end time is set.
SMP 86 M _/F
B
– 10 –
The end time and duration settings define
„ „
programme start time as follows:
start time = end time - duration.
After setting the duration and end time, the
„ „
display still shows the end time.
The programme starts when the time of day
„ „
coincides with the start time: the Auto symbol
lights up steadily and the symbol
flashing.
After the start of cooking, the display shows
„ „
the countdown. If only the end of cooking time
is selected (the duration is = 0), cooking starts
and the display shows the countdown.
The Auto symbol remains lit during the wait
„ „
for delayed start and for the entire duration of
cooking.
The symbol flashes during the wait for
„ „
delayed start and remains fixed when cooking
starts.
An acoustic signal sounds at the end of
„ „
cooking; to silence it, press Set or allow the
signal to continue for its duration.
Semiautomatic programme with duration or
end time
Programme time setting
To select the programme duration or end time
X X
press the Mode or Set button twice and set the
required time with the + and – buttons.
During duration or end time adjustment mode
„ „
selection, the corresponding Auto symbol
flashes.
Once a programme duration is set, the end
„ „
time cannot be decreased. Likewise, the
duration of a programme cannot be prolonged
once the end time is set.
Programme run
When the automatic programme is in progress
„ „
(and therefore the cooking function is active),
the Auto symbol remains lit and the remaining
cooking time appears on the display in
countdown form. The symbol
Automatic programme end
At the end of the programme duration or when
„ „
the end time is reached, the corresponding
symbol goes off.
At the end of the automatic programme, the
„ „
Auto symbol flashes, the display shows "End"
and an intermittent acoustic signal (which can
be stopped by pressing Set) sounds.
starts
also remains lit.