Mechanical Cooking Programmer; Digital Cooking Programmer - Franke SMART PLUS SGP 62 M /F Manuel D'installation Et Mode D'emploi

EN
begins to flash); then turn the knob to move
the hands in order to set the end of
cooking time.
„ „
The LED will blink for the next
10 seconds (for possible adjustments),
after which the setting will be acquired
and the LED becomes steady.
„ „
The same effect is obtained by
pressing the knob twice during
blinking. At the end of cooking, oven
heating will be deactivated and the
ringer will sound for 1 minute; this
sound can be stopped by pressing
the knob.
Note: At the end of cooking, the oven remains
at a temperature close to the previously set
value for several minutes; it is therefore wise
to remove the food from inside so as to avoid
overcooking it.
End of cooking
start
X X
Delayed start of cooking can only be
activated following the end of a cooking
A
process; when set, pressing the knob
confirms the „stop", and activates the
blinking LED for the symbol
X X
Turn the knob to also set the start of
cooking time (naturally this will be before
the end, therefore the hands can only be
moved back).
X X
Confirm by pressing the knob again.
X X
The data can also be automatically acquired
by allowing the blinking to continue for
10 seconds.
„ „
The LEDs for symbols
will remain lit and the oven will switch
on at the set time, when only the LED
for the symbol
„ „
At the end of cooking, the ringer will
sound for 1 minute; this sound can be
stopped by pressing the knob.
Setting the time of day
X X
To set the correct time, just press the knob
three times (the LED for the clock symbol
starts blinking), then turn the knob.
X X
After setting the right time, press the knob
to confirm.
SGP 62 M _/F / SMP 62 M _/F / SMP 66 M _/F / CF 65 M _/F
with delayed
.
and
will remain lit.

Mechanical cooking programmer

(Fig. 1b)
End of cooking timer knob (B)
The end of cooking timer is a practical device
that turns the oven off automatically at a set
time in an interval of 1 to 120 minutes.
9 To use the end of cooking timer, the ringer
must be wound up by turning the knob
(B) almost one full turn clockwise; then,
turning back, set the required time by
aligning the number corresponding to the
minutes with the fixed reference on the
front panel.
„ „
At the end of the set time, the ringer
sounds and the oven is automatically
switched off.
Note: The oven stays hot at around the set
cooking temperature for a long time after
it has been switched off; therefore to avoid
overcooking or burning the food, it is advisable
to remove it from the oven.
B
Note: To use the oven in manual mode, i.e.
without using the end of cooking timer, align
the knob (B) pointer with the fixed symbol
on the front panel. When the oven is turned off,
the end of cooking programmer can be used as
a normal timer.

Digital cooking programmer

(Fig. 1a)
It enables oven programming in the following
modes:
– delayed start of cooking with set duration,
– immediate start of cooking with set
duration;
– timer.
– 10 –