−
6.
Run the snowblower at an adequate speed by operating the main
shift lever.
−
7.
After running, turn the engine switch to the STOP position.
Use the battery run system to drive the snowblower in case the
engine does not start.
The battery run system consumes battery power. Take care not to
operate the battery run system for longer than 3 aggregate minutes
and operate it with the battery fully charged. Operating the battery
run system for longer than 3 minutes or frequent operation will
discharge the batteries, which prevents you from starting the engine
and snowblower.
Be sure to turn the engine switch to the STOP position after starting
with the battery run system. Leaving the engine switch at the ON
position will discharge the battery and may cause an accident.
Recharge the battery as needed (see page
The battery run system allows you to drive the snowblower when
the engine is not running.
Be sure to set the main shift lever in the N (neutral) position before
starting the battery run system.
The snowblower may not start under the following conditions. If it
does not start, move the snowblower to a safe place by removing
the wheel pins (see page
·
Battery is discharged.
·
Drive motor is faulty.
·
Wheel pin(s) is/are broken or missing.
·
Motor drive controller is faulty.
105
).
89
).
65