Honda HSM1590i Manuel De L'utilisateur page 104

SYMPTOM
Snow discharge
chuter does not
throw snow well.
Auger runs up onto
and does not cut
into hard snow.
Auger housing
becomes clogged
with snow.
Auger is in contact
with the road
surface.
Snowblowing
mechanism makes
an abnormal noise.
Snow discharge
chuter direction can
not be set.
POSSIBLE CAUSE
Engine is overloaded.
[SELF mode only]
Engine speed is too low.
[SELF and POWER mode
only]
Blower is deformed.
Blower lock bolt is broken.
Auger lock bolt is broken.
Snow discharge chute is
angled down.
Auger height is not proper.
Auger lock bolt is broken.
Auger is worn.
Blower lock bolt is broken.
The height of skid and
scraper is not proper.
Auger height is not
adjusted properly.
Skid and scraper height is
not adjusted properly.
The shape of the shaft and
wing of the auger and/or
blower is deformed.
Fuse is blown out.
Motor is overheated
(breaker tripped).
Motor or switch or relay is
faulty.
REMEDY
Lower the driving speed (see
page 58).
Move the throttle control lever
to the FAST position (see page
54 or 55).
Replace the blower (see page
80).
Replace the blower lock bolt
(see page 79).
Replace the auger lock bolt (see
page 79).
Adjust so that the snow
discharge chute is angled up
(see page 49 or 52 or 55).
Adjust the auger height (see
page 49 or 52 or 55).
Replace the auger lock bolt (see
page 79).
Replace the auger (see page 80).
Replace the blower lock bolt
(see page 79).
Adjust the skid and scraper (see
page 42 44). −
Adjust the auger height (see
page 49 or 52 or 55).
Adjust the skid and scraper (see
page 42 44). −
Consult an authorized Honda
dealer.
Fuse check or replacement (see
page 86).
Wait for a while. Do not keep
pushing operation lever.
Consult an authorized Honda
dealer.
101