Honda HSM1590i Manuel De L'utilisateur page 57

MAIN SHIFT LEVER
MAIN SHIFT LEVER
THROTTLE CONTROL LEVER
DRIVE CLUTCH LEVER
AUGER CLUTCH SWITCH
54
6) Move the main shift lever fully to the
end of the forward low speed range
slowly and clear the snow.
When the auger hits against the
road or inclines to a side, adjust the
LOW
a u g e r h o u s i n g p o s i t i o n b y
RANGE
operating the auger housing control
switch.
When the snow is small in volume
or light in nature, move the main
shift lever to the high speed side.
Perform minor adjustment of the
main shift lever to stabilize the
operating speed if necessary.
FAST
RANGE
7) After stabilizing the operating speed,
adjust the snow discharge distance by
operating the throttle control lever as
needed.
Traveling speed will decrease by
increasing the snow discharge
distance, while the speed will
increase by decreasing the snow
discharge distance. Adjust the snow
discharge distance by operating the
throttle control lever as needed.
8) When the drive clutch lever is released,
the auger clutch switch indicator
(green) goes off, both the auger and
b l o w e r s t o p t u r n i n g , a n d t h e
snowblower stops moving.
To move from one place to another, or
to change direction, use the drive
clutch lever only. Release the drive
clutch lever once, then squeeze the
drive clutch lever again.