Honda HSM1590i Manuel De L'utilisateur page 87

3. Disconnect the negative ( ) cable at the battery A negative ( )
terminal and put the tube on the terminal.
4. Disconnect the positive ( ) cable at the battery B positive ( )
terminal and put the tube on the terminal.
5. Loosen the nuts holding the battery set plate.
6. Disconnect the battery joint cable at the battery B negative ( )
terminal and at the battery A positive ( ) terminal.
NEGATIVE ( ) CABLE −
NUTS
7. Remove the battery and clean the battery terminals and battery
cable terminals with a wire brush or sand paper.
Clean the battery with a solution of baking soda and warm water
with care not to get the solution or water in the battery cells. Dry the
battery thoroughly.
Two 12V batteries are connected in series.
84
−
＋
POSITIVE ( ) ＋
TERMINAL
NEGATIVE ( )
TERMINAL
＋
POSITIVE ( ) CABLE
BATTERY JOINT CABLE
BATTERY B
BATTERY A
−
(Two 12 V batteries are connected in series)
−
＋
−
＋
BATTERY SET PLATE
NEGATIVE ( ) −
TERMINAL
POSITIVE ( ) ＋
TERMINAL
TUBES