Honda HSM1590i Manuel De L'utilisateur page 59

AUGER CLUTCH SWITCH
The auger and blower will start to turn when the drive clutch lever
and auger clutch switch is operated. Check around the snowblower
for safety before operating the lever and switch.
MAIN SHIFT LEVER
56
5) Push the auger clutch switch to
operate on the auger and blower.
The indicator (green) comes on
when you push the auger clutch
switch.
When the auger clutch switch is
pushed for four seconds or longer,
the protection function gets armed.
This stops the auger and blower
from turning.
The auger and blower keep turning
while the drive clutch lever is
squeezed. Push the auger clutch
switch again to stop the auger and
blower. (Interlocking operation of
the drive clutch lever and auger
clutch switch)
6) Adjust the operating speed by moving
the main shift lever to a position
w i t h i n t h e s l o w s p e e d r a n g e
according to the volume and nature of
the snow, and clear the snow.
LOW
Even when you are clearing the
RANGE
snow, adjust the operating speed as
needed by operating the main shift
lever according to the change of the
volume and nature of the snow.
When the snow is small in volume
or light in nature, move the main
shift lever to the high speed side.
Perform minor adjustment of the
main shift lever to stabilize the
operating speed if necessary.