Honda HSM1590i Manuel De L'utilisateur page 30

Reset switch
Use the reset switch to return the auger housing to the reset position
(current set position). This switch is convenient to move the auger
housing by operating the auger housing control switch and to return
the auger housing to the original position. The reset position has been
set at the factory in the position where the snow clearing part contacts
the ground with the snowblower set on a level ground.
The reset position can be changed (see page
changing procedure).
OFF
Skid, Scraper
Adjust the skid and the scraper according to the road surface condition
where you are to clear the snow. Use the skid to determine the height
from the ground to the auger, and adjust the scraper to make the snow
surface even (see page
O O
ON
42 ).
SKID SCRAPER
66
O O F F F F
N N
RESET SWITCH
AUGER
for reset position
27