Throttle Control Lever; Reset Switch - Honda HSM1590i Manuel De L'utilisateur

3c. Clearing in SELF mode
Nothing is controlled automatically when the mode selector
switch is set at the SELF position. Engine speed and operating
speed can be adjusted freely by selecting the SELF mode.

THROTTLE CONTROL LEVER

SELF mode
CHUTER CONTROL SWITCH

RESET SWITCH

AUGER HOUSING CONTROL SWITCH
MAIN SHIFT LEVER
DRIVE CLUTCH LEVER
1)
2)
3)
N (neutral)
4)
Set the throttle control lever in the
third position from the bottom.
Operate the chuter control switch to
adjust the snow discharge direction
and angle (see page
Operate the auger housing control
switch to adjust the auger to be
parallel to the road surface (see page
26 ).
You can return the auger to the
initial height position by pushing
the reset switch.
If you return the auger to the initial
height position by pushing the reset
switch, the auger can hit against the
road surface or can be raised from
the road, resulting in some snow
left on the ground, depending on
the road condition and the position
of the snowblower. Adjust the auger
height position as needed.
Check that the main shift lever is in the
N (neutral) position and squeeze the
drive clutch lever.
25 ).
55