Honda HSM1590i Manuel De L'utilisateur page 55

3b. Clearing in POWER mode
With the mode selector switch in the POWER position you can
adjust the engine speed and snow discharge distance. Use the
throttle control lever to adjust the engine speed, which determines
how fast snow is picked up and how far it is thrown. Use the
chuter control switch to adjust height and direction of the snow
discharge.
Note that the throttle control lever only functions after the auger
is turning. The engine speed is maintained automatically in
POWER mode.
THROTTLE CONTROL LEVER
POWER mode
CHUTER CONTROL SWITCH
RESET SWITCH
AUGER HOUSING CONTROL SWITCH
52
1) Set the throttle control lever in the
third position from the bottom.
2) Operate the chuter control switch to
adjust the snow discharge direction
and angle (see page
3) Operate the auger housing control
switch to adjust the auger to be
parallel to the road surface (see page
26 ).
You can return the auger to the
initial height position by pushing
the reset switch.
If you return the auger to the initial
height position by pushing the reset
switch, the auger can hit against the
road surface or can be raised from
the road, resulting in some snow
left on the ground, depending on
the road condition and the position
of the snowblower. Adjust the auger
height position as needed.
25 ).