Channel Input Configuration; X-Plus Input Configuration; Trim Setup - Spektrum DX18t Manuel D'utilisation

Channel Input Configuration

x-Plus Input Configuration

Trim Setup

Use the Trim Setup screen to change the size of the trim
step and the trim type.
Trim Step
Adjusting the trim step value determines how many "clicks" of trim
you input each time you press the trim button. Changing the trim
step value to 0 disables the trim for the channel.
To change the trim step value
1. Scroll to the trim step channel you wish to change.
2. Select the trim step value and scroll left or right
to change the value.
3. Press the scroll wheel to save the selection.
Trim Type
The two Trim Type options are Common and F Mode.
Common trim type maintains the same trim values for all
flight modes.
F Mode trim type enables you to save trim values for individual
flight modes if you find, for example, the aircraft requires aileron
trim in Flight Mode 1 but not in Flight Mode 2.
Trim Assignment
In a few instances, you can reassign a trim to a different location.
SPEKTRUM DX18t • TRANSMITTER INSTRUCTION MANUAL
The Channel Input Configuration screen enables you to assign a transmitter channel
to a different control stick or switch.
1. Select NEXT on the RX Port Assignments screen to access the Channel Input
Configuration screen.
2. Scroll to the transmitter channel you wish to re-assign and press the scroll wheel.
The box around the current input selection flashes.
3. Scroll left or right to select the desired control stick or switch.
4. Press the scroll wheel to save the selection.
The X-Plus Input Configuration screen enables you to assign any X-Plus channel
to any transmitter input.
1. Select NEXT on the Channel Input Config screen to access the X-Plus Input Config screen.
2. Scroll to the X-Plus channel you wish to change.
3. Press the scroll wheel once and scroll left or right to change the X-Plus Input for that
X-Plus channel.
Aircraft Model Type
Throttle Trim Type
Helicopter Model Type
Trim location
Normal and Cross trim types are available. Normal trims align
with the control stick. For example, the throttle trim is next
to the throttle stick.
Cross trims reverse the position of the trims; for example,
the throttle trim is next to the elevator stick and vice versa.
To change the Trim Position from Normal to Crossed, select Normal
at the bottom of the Trim Setup screen and press the scroll wheel.
IMPORTANT: Crossed trims will cross both sets of trims
for both gimbals.
Throttle
• Throttle Digital trim button (default)
• Left Analog lever
• Right Analog lever
• Common
• Flight Mode
• 2-Pos
• 3-Pos
Tip: With throttle trim set to 3-Pos, the throttle trim will
function as a 3-position throttle trim where the throttle trim
can be set to low, middle, and high. This can be helpful for
turbine set up.
Throttle and Pitch Hover Trim—used to trim the throttle and
pitch setting for precision hovering. This does not affect normal
throttle trim operation.
• P1
• P2
• P3
• P4
EN
15