Preflight Setup; Frame Rate; Bind - Spektrum DX18t Manuel D'utilisation

EN
File Name
1. Select File Name to assign a custom file name.
2. The File Name screen appears, allowing you to name the file
as you would for a Model Name or Flight Mode Name. The file
name can include a maximum of 8 characters.
3. Press BACK to save the name.
Start
1. Select Start to assign a specific switch position or stick
position that activates Data Logging.
2. Press the scroll wheel once to save the selection.

Preflight Setup

Frame Rate

The Frame Rate menu enables you to change the frame rate
and modulation mode. Select the option you wish to change
and press the scroll wheel.
You must use digital servos if you select 11ms frame rate.
Analog and digital servos can be used with a 22ms frame rate.
Modulation Mode
We recommend using DSMX
When DSMX is active, the transmitter operates in DSMX with
DSMX receivers and DSM2
®
automatically detects DSM2 or DSMX during binding and changes
the mode accordingly to match the receiver type you are using.
If you select DSM2, the transmitter operates in DSM2 regardless
of whether it is bound to a DSM2 or DSMX receiver.

Bind

18
The Preflight Setup menu option enables you to program a pre-flight checklist that appears
each time you power on the transmitter or when you select a new model memory. Each item
on the list must be confirmed before you can access the Main Screen.
(default) modulation mode.
®
with DSM2 receivers. The transmitter
The Bind menu enables you to bind a transmitter and receiver without powering off the
transmitter. This menu is helpful if you are programming a model and need to bind the
receiver for failsafe positions. See "Programming Failsafe Positions" for more information.
Enabled
When Enabled is set to NO, Data Logging is turned off. Select
YES to save Telemetry data to the SD Card. The SD Card must be
installed in the transmitter to select YES.
CAUTION: If you access the Telemetry menu from
the Function List, you may see a Frame Loss appear when
you exit the menu. The Frame Loss is not an error, but there
will be a momentary loss of radio signal when exiting the
Telemetry screen. Do NOT access the Telemetry menu
during flight.
NOTICE: While DSMX allows you to use more than
40 transmitters simultaneously, do not use more than
40 transmitters simultaneously when using a DSM2
receiver or a transmitter in DSM2 mode.
Bind Progress
The Bind Progress menu enables you to activate or inhibit
voice alerts for the binding process. The alerts are set to
Voice by default.
This menu is accessed by selecting NEXT in the Frame Rate menu.
To activate or inhibit bind voice alerts
1. Select the alert you wish to change.
2. Press the scroll wheel to change the value.
3. Select BACK to save the selections.
SPEKTRUM DX18t • TRANSMITTER INSTRUCTION MANUAL