Spektrum DX18t Manuel D'utilisation page 7

Mode Change
The DX18t is in Mode 0 from the box. The desired mode must be
manually set prior to operation using the screws on the back of the
transmitter. You can change the mode in System Settings, under
the System Setup menu. Screw in the star-shaped screw until
you are not able to turn or when the cantilever arm has fully
disengaged. Adjust the tension screws to your preference.
Throttle Strap
Tension
Elevator
Tension (2)
Mode
Change 1/3
Aile/Rudd
Tension (2/1)
SPEKTRUM DX18t • TRANSMITTER INSTRUCTION MANUAL
Audio Jack Trainer Port
(under antenna) (under antenna)
EN
Aile/Rudd
Tension (1/2)
Mode
Change 2/4
Elevator
Tension (1)
Mode
Change 2/4
7