Cleaning The Twin Whisk; Cleaning The Pot; Descaling The Pot; Cleaning The Tool Holder - Bosch MCC9555FWC Manuel D'utilisation

en Cleaning and servicing
20.7 Cleaning the twin whisk
Remove both beating whisks from
1.
the twin whisk.
Carefully clean all parts under run-
2.
ning water using a brush.
Dry all parts.
3.
Position the beating whisks vertic-
4.
ally on the pins and push in firmly.
The beating whisks must move
easily.
a The beating whisks engage aud-
ibly.
Tip: You can clean the twin whisk in
the dishwasher.
20.8 Cleaning the pot
Requirement: The tool has been re-
moved. → Page 102
Clean the pot thoroughly.
1.
Wipe down the pot with a soft,
2.
damp cloth and then dry.
Note: If you are cleaning the pot in
the dishwasher, remove the tool
holder.
Tips
¡ You can clean the pot in the dish-
washer.
¡ You can remove light discoloura-
tion on the bottom of the pot with
water and a little vinegar.
→ "Descaling the pot", Page 122
122
20.9 Descaling the pot
Requirement: The first signs of
limescale are visible.
Take the pot out of the main unit.
1.
Use a normal household descaler
2.
in the pot according to the instruc-
tions.
Clean the pot with a dishwashing
3.
brush or soft cloth.
Rinse the pot with plain water.
4.
Dry the pot.
5.
20.10 Cleaning the tool
holder
Remove the tool holder.
1.
→ Page 120
Remove the silicone sealing ring
2.
from the tool holder.
Clean the silicone sealing ring with
3.
a soft cloth under running water.
Clean the tool holder with a brush
4.
under running water.
Dry all parts.
5.
Insert the tool holder with the silic-
6.
one sealing ring.
Turn the pot on its side.
7.
Tighten the threaded ring with
8.
wings as far as it will go.
a The symbols
Tip: You can clean the tool holder
and the silicone sealing ring in the
dishwasher.
and line up.