Fitting The Lid; Connecting The Appliance To The Electricity Supply; Performing Initial Start-Up - Bosch MCC9555FWC Manuel D'utilisation

en Installation and connection
4.6 Fitting the lid
WARNING
Risk of crushing!
Your hands and fingers could get
caught.
Do not reach into the pot when
▶
lowering the lid.
Tip: Familiarise yourself with the
parts of the lid.
→ "Lid", Page 98
Requirement: The pot has been in-
serted. → Page 91
Insert the outer lid with seal fully
1.
into the lid holder
and close.
a The outer lid with seal engages in
the lid holder.
Place the cover for the outer lid on
2.
the outer lid with seal.
a The symbols
92
on the pot
and line up.
Turn the cover for the outer lid
3.
clockwise towards
ticeably engages.
a The symbols
Place the inner lid on the cover for
4.
the outer lid.
Turn the inner lid clockwise until it
5.
engages.
a The drive is ready to use.
4.7 Connecting the appliance
to the electricity supply
Connect your appliance to the power
supply to start it up for the first time.
Insert the mains plug of the appli-
1.
ance's power cable in a socket
nearby.
Make sure that the power cord is
not pulled too tight and is not
covered up.
To adjust the cable length, push
the power cord into the power
cord storage compartment.
Check the mains plug is inserted
2.
properly.
4.8 Performing initial start-up
When switching on the appliance for
the first time or after resetting to the
factory settings, the tutorial will ap-
pear. The tutorial explains all import-
ant functions and tools and will
prompt you to select settings.
until it no-
and line up.