Setting The Clock; Selecting The Display Language; Setting The Buzzer Volume; Self-Monitoring Functions Overview - Hürner HST300 Print+ Manuel De L'utilisateur

H Ü R N E R S c h w e i s s t e c h n i k G m b H
Nieder-Ohmener Str.
35325 Mücke, Germany
ogy defined therein. This means that the user will be guided through
the data input screens for the following bar code elements:
• Welder/User Code
• Job/Commission Number
• Fitting Welding Code
• Fitting Traceability Code (Second Fitting Code)
• First Pipe Code
• Second Pipe Code
A precondition is that the fittings and components are actually
equipped with these bar code elements.
"Print Additional Data on" means that the additional data saved in the
welding report in system memory will also be printed, "off," that they
won't be printed.
"Set Clock M " means that by pressing the MENU key, the user can
access a sub-menu for setting the clock.
"Select Language M " means that by pressing the MENU key, the
user can access a sub-menu for selecting the display and print
language.
"Adjust Volume M " means that by pressing the MENU key, the user can
access a sub-menu for setting the volume of the buzzer.

10.2 Setting the Clock

When the "Set Clock" sub-menu was selected, the screen changes to
the display reproduced in Display 19.
The time of day and the date can be set using the keypad. The portions
"Hour," "Minute," "Day," "Month," and "Year" are set separately. Press the
START key to confirm your settings.

10.3 Selecting the Display Language

When the "Select Language" sub-menu was selected, the screen changes
to the display reproduced in Display 20.
Use the arrow keys  and  to select one of the options, "Deutsch,"
"English," "Français," "Español," and "Dansk" and confirm your selection
by pressing the START key.

10.4 Setting the Buzzer Volume

When the "Set Volume" sub-menu was selected, the screen changes
to the display reproduced in Display 21. The buzzer can also be heard.
Turn the buzzer volume up or down to the desired value using the ,
 arrow keys (from 0 to 70) and confirm your setting by pressing the
START key.
11

Self-Monitoring Functions Overview

11.1 Errors During Data Input

11.1.1 Code Error

Erroneous input, poor code tag, error in code symbology or improper
code reading.

11.1.2 No Contact

There is no properly established electric contact between the welding
unit and the fitting (check connection terminal pushed on fitting), or the
heater coil is defective.
Version February 2009 HST300 Print+ User's Manual
Set Clock/Date
10:25 06.09.02
Display 19
CHOOSE LANGUAGE
>Deutsch
English
Francais
Display 20
ADJUST VOLUME
0-----35-----70
Turn up
à
Turn down

Display 21
EN
15