Selecting The Display Language; Setting The Clock; Setting The Buzzer Volume; Selecting The Temperature Unit - Hürner HST 300 GeoTherm+ 2.0 Manuel Utilisateur

9.1.1 Selecting the Display Language

When the "Select Language" sub-menu was selected, the screen
changes and the display reproduced in Display 13 appears.
Use the arrow keys ñ and ò to select one of the options, "Deutsch,"
"English," and "Français" and confirmby pressing the START/SET
key.

9.1.2 Setting the Clock

When the "Set Clock" sub-menu was selected, the screen changes and
the display reproduced in Display 14 appears.
The time of day and the date can be set using the keypad. The portions
"Hour," "Minute," "Day," "Month," and "Year" are set separately.
Press the START/SET key to confirm your settings.

9.1.3 Setting the Buzzer Volume

When the "Set Volume" sub-menu was selected, the screen changes
and the display reproduced in Display 15 appears. The buzzer can also
be heard. Turn the buzzer volume up or down to the desired value
using the ï, ð arrow keys (from 0 to 100) and confirm your setting
by pressing the START/SET key.

9.1.4 Selecting the Temperature Unit

The unit of temperature values (Centigrade or Fahrenheit) can
be selected in a sub-menu similar to the language selection (see
Sect. 9.1.1).
9.2

Understanding the "Recording" Sub-menu

"Welder Code on" means that the welder identification code has to
be entered as set with "Welder Code Options," "off," that this
is impossible.
"Commission Number on" means that the commission number (job
number) will have to be entered or confirmed before every new
welding, "off" that the user is not prompted to enter it.
All data can also be read from a bar code with the scanner,
provided such a bar code is available.
Info
10

Self-Monitoring Functions Overview

10.1 Errors During Data Input

10.1.1 Code Error

An erroneous input has occurred, a code tag is poor or has an error in
code symbology or code reading was improper. (This error may also
indicate that a code for a fitting sized larger than 75 mm was read
or entered.)

10.1.2 No Contact

There is no properly established electric contact between the welding
unit and the fitting (check push-on terminal on fitting), or the heater
coil is defective.
14
EN
HÜRNER HST 300 GeoTherm + 2.0 User's Manual
H Ü R N E R S c h w e i s s t e c h n i k G m b H
Nieder-Ohmener Str. 26
35325 Mücke, Germany
***** LANGUAGE *****
>Deutsch
English
Francais
Date/Time
21.06.13
Buzzer Volume
< ------20-------- >
Data Recording
Welder Code
>Commission No.
Display 13
14:28
Display 14
Display 15
on
on
Display 16
Version July 2013