Additional Information In The Welding Report; Free Data Input; Entering Or Changing The Job Number; Entering Or Changing Additional Data - Hürner HST300 Print+ Manuel De L'utilisateur

6

Additional Information in the Welding Report

Every reporting protocol saved to system memory contains a number of
welding and traceability data, which the operator can decide to enter or
not to enter in the set-up menu. These data can then be sent to a desktop
printer or processed further on a PC with the welding report management
software DataWork.
6.1

Free Data Input

Use the  arrow key to switch to free data input. This will cause a display
to appear on the screen in which you can select "Enter Job Number" or
"Enter Additional Data" using the  and  arrow keys.
6.2

Entering or Changing the Job Number

When "Enter Job Number" was chosen in the free data input menu, the
screen shows the display that allows entering the job number of a given
commission. This input can be entered either using the arrow keys , ,
,  or by reading it from a bar code using the scanning pen. The maxi-
mum length is limited to 32 characters. Confirm your input by pressing
the START key. The job number will be saved to memory and will appear
in the printed welding report.
6.3

Entering or Changing Additional Data

When "Enter Additional Data" was chosen in the free data input menu,
the screen shows first the display that allows entering the first additional
data, then the one for the second additional data. This input can be en-
tered either using the arrow keys , , ,  or by reading from a bar
code using the scanning pen.
For the "Enter Additional Data 1" screen, the maximum length is 20 char-
acters. Confirm your input by pressing the START key. The additional data
will be saved to memory and will appear in the printed welding report. By
pressing STOP/RESET, you skip this screen and do not save anything.
For the "Enter Additional Data 2" screen, the maximum length is 15 char-
acters. Confirm your input by pressing the START key. The additional data
will be saved to memory and will appear in the printed welding report. By
pressing STOP/RESET, you skip this screen and do not save anything.
Note:
You are free to define any additional data you see fit. For instance, you
can put into these fields information on pipe length, ditch depth, or com-
ments that help with welding traceability.
6.4

Entering Weather Conditions

If the weather conditions feature is enabled in the system set-up, this
input is required before the fitting code can be entered.
Use the arrow keys ,  to select from "sunny," "dry," "rain," "wind," "tent,"
and "heating." Press the START key to confirm your selection. The selec-
tion is saved to memory and will appear in the printed welding report.
6.5 Entering the 2 Fitting Code
nd
If the ISO data feature is enabled in the system set-up, after the fitting
code was entered, the input "Enter 2
This input is entered either from a bar code using the scanning pen or
manually using the arrow keys , , , . Press the START key to
confirm your input. If the code entered is not correct, a "Code Error"
message appears; check the string of numbers and correct as needed.
10
EN
Fitting Code" is required.
nd
HST300 Print+ User's Manual
H Ü R N E R S c h w e i s s t e c h n i k G m b H
Nieder-Ohmener Str.
35325 Mücke, Germany
* FREE DATA INPUT
>Enter Job No.
Enter Add. Data
Enter Job No.
********************
************
Enter Add. Data 1
********************
SELECT WEATHER
>sunny
dry
rain
Version February 2009
*
Display 6
Display 7
Display 8
Display 9