Print Menu; Printing All Reports; Printing A Commission Number; Printing On Paper - Hürner HST300 Print+ Manuel De L'utilisateur

USB B Interface (at the back of the unit)
for connecting the welding unit directly to a PC
Both interfaces comply with the USB version 1.1 specification (i.e., maxi-
mum data rate of 12 megabits per second).
To work properly, the used printer has to support PCL (Printer
Command Language). Please refer to the manual of your
printer for more information. A list of supported printer makes
Important
is also available from Hürner Schweisstechnik on-line at
www.huerner.de
Before printing or transferring data, it is highly recomended to
switch the welding unit off and on again. If this fails to happens,
there is a risk of data transfer failure, or reports in the welding
Important
unit may be corrupted.
8.1

Print Menu

Connecting the printer cable causes the print menu to appear. Using the
 and  arrow keys, select from "Print All Reports" and "Print Commis-
sion Number." Confirm your selection by pressing the START key.
8.2

Printing All Reports

If the "Print All Reports" option is selected in the print menu, all reporting
protocols currently in system memory are sent to the printer or the PC.
8.3

Printing a Commission Number

If the "Print Commission Number" option is selected in the print menu, the
first available commission number is displayed. Use the  and  arrow
keys to select one of the commissions currently in system memory. When
you press the START key, you cause the data of the selected commission
number to be transferred to the printer or PC.
8.4

Printing on Paper

Printing starts automatically after a selection was made in the print menu.
If the printer is not connected to the USB A interface at the front of the
welding unit, the unit display a "Printer not ready" error message on the
screen. Connect the printer to the interface and wait for all the selected
reports to print off and the "Printing finished" message to appear on the
screen.
If a problem occurs while printing is in progress (no paper in bin, paper
jam, ink or toner used up), the "Printer not ready" message shows again.
After the problem condition is cleared, printing resumes automatically.
If the welding unit recognizes a problem that cannot be cleared
while printing or data transfer is in progress, it does not resume
printing or transfer and displays a "Printing interrupted" error
message.
Info
8.5

Data Tranfer to a USB Stick

Transferring welding reports to a USB stick is analogous to printing them
off on paper with a PCL-compatible USB printer. Instead of the USB cable
of a printer, stick the USB stick into the USB A interface at the front of
the welding unit, then wait for all the selected reports to print off and the
"Printing finished" message to appear on the screen.
12
EN
HST300 Print+ User's Manual
H Ü R N E R S c h w e i s s t e c h n i k G m b H
Nieder-Ohmener Str.
35325 Mücke, Germany
** PRINT MENU
>Print All Reports
Print Commission No
Version February 2009
**
Display 14