Electrical Hook-Up - Mondolfo Ferro TBE160 TERRA Manuel D'utilisation

Les langues disponibles

WARNING

The floor must be able to support a load equal to the sum of the weight of the

equipment plus the maximum load allowed, taking into consideration also the rest-

ing base and any fixing means envisaged.

The TYRE CHANGER must be powered with three-phase current plus a neutral wire.

The power supply voltage must be specified in the purchase order.

WARNING

Any operations to hook up to the electrical board of the workshop must only be

carried out by qualified personnel, in accordance with the regulations of the cur-

rent laws, and this is the duty and responsibility of the customer.

The electrical hook-up must be performed according to:

• absorbed power specifications indicated on the machine dataplate.

• the distance between the machine and the power supply hook-up point, so that

voltage drops under full load do not exceed 4% (10% during start-up) compared with

the rated voltage specified on the data plate.

- The operator must:

• a dedicated power plug in compliance with the relevant electrical safety standards.

• connect the machine to its own electrical connection fitted with a suitable differential

circuit breaker with 30mA sensibility and an intervention threshold of 100mA and a

32A automatic thermal magnetic switch with a "D" type intervention curve;

• mount power line protection fuses, suitably sized according to the specifications

indicated on the main wiring diagram contained in this manual;

• a suitable earthing system installed on the workshop mains line.

- Prevent unauthorised use of the machine, always disconnect the power supply

plug when the machine is not used (switched off) for extended periods of time.

If the machine is connected directly to the power supply by means of the main

electrical panel and without the use of a plug, a key-operated or padlockable

switch must be installed to restrict machine use exclusively to qualified personnel.

WARNING

For the correct functioning of the machine it is vital to have a good ground connec-

tion. NEVER connect the machine ground wire to a gas pipe, water pipe, telephone

cable or any other unsuitable object.

- E

- Operator's manual

nGlISH