Electrical Hook-Up; Safety Regulations - Mondolfo Ferro TB125 Manuel D'utilisation

ELECTRICAL HOOK-UP

The tyre changer must be powered with three-
phase current plus ground. The power supply volt-
age must be specified in the purchase order.
WARNING
All operations required for the electrical con-
nections of the equipment must be carried
out exclusively by a qualified electrician.
- The electrical supply must be suitably sized
in relation to:
• absorbed power specifications indicated on
the machine data plate.
• the distance between the machine and the
power supply hook-up point, so that voltage
drops under full load do not exceed 4% (10%
during start-up) compared with the rated
voltage specified on the data plate.
- The user must:
• fit a power plug that complies with the
relevant electrical safety standards.
• connect the machine to its own electrical
connection fitted with a suitable differential
circuit breaker.
• mount power line protection fuses, suitably
sized according to the specifications indi-
cated on the main wiring diagram contained
in this manual;
• install an efficient grounding circuit to
protect the workshop electrical system.
- To prevent unauthorised use of the machine,
always disconnect the mains plug when the
machine is not used (switched off) for ex-
tended periods of time.
-
If the machine is connected directly to the
power supply by means of the main electri-
cal board without a separate plug, install
a key-operated switch (or at least a switch
that can be locked) to restrict machine use
to authorised personnel only.
WARNING
For the correct functioning of the machine
it is vital to have a good ground connection.
NEVER connect the machine ground wire to a
gas pipe, water pipe, telephone cable or any
other unsuitable object.
42

SAFETY REGULATIONS

The equipment is intended for professional
use only.
CAUTION
Only one operator may work on the equipment
at a time.
WARNING
Failure to comply with the instructions and
danger warnings can cause serious injuries
to the operator or other persons.
Before starting up the equipment, always
ensure you have read and understood all the
danger/warning signs in this manual.
In order to operate the machine correctly, it
is necessary to be a qualified and authorised
operator, able to be trained and to know the
safety regulations. Operators are expressly
forbidden from using the machine under the
influence of alcohol or drugs capable of affect-
ing their capacity to perceive danger.
The following conditions are essential:
- read and understand the information and
instructions described in this manual;
- have a thorough knowledge of the features
and characteristics of the machine;
- keep unauthorised persons well clear of the
working area;
- make sure that the machine has been installed
in compliance with all relevant standards and
regulations in force;
- make sure that all machine operators are suit-
ably trained, that they are capable of using
the machine correctly and safely and that they
are adequately supervised during work.
- do not touch power lines or the inside of
electric motors or other electrical equip-
ment before making sure that they have been
powered off;
- read this booklet carefully and learn how to
use the machine correctly and safely;
- always keep this operator manual in a place
where it can be easily accessed and do not
neglect to consult it.
WARNING
Do not remove or deface the DANGER, WARN-
ING, CAUTION or INSTRUCTION decals. Replace
any missing or illegible decals. If one or more
- E
nglIsh
- User Manual TB125