A.3 Software; User Interface - AOIP CALYS 150 Mode D'emploi

A.3 Software

The firmware of the CALYS 150 is stored in flash memory. It is therefore easy to update the firmware when a new version
is available. Refer to paragraph A.5.1 for detailed information on updating the firmware.

User Interface

The basic items forming the user interface are shown in the diagram below:
The "on-line help" function is not visible in the menu, but is accessible at any time by pressing the
a help window for the function in use appears. The
The main menu is located at the bottom of the screen, opposite the four function keys (F1 to F4). To select an item from the
menu, press the associated function key.
Navigation within menus and sub-menus is by means of the navigation keys and the ENTER key.
For example, to display the% FS menu in the example of the screen below, perform the following steps:
1) Press the F4 key associated with the proposed Mode from the main menu.
2) Press the Down
key.
3) Press the Down navigation key
box associated with this function appears and the four function keys change their function automatically to suit the
dialogue box.
It is possible to cancel the selection at any time and return to the main menu by pressing the ESC key.
navigation key twice to select the Predefined settings sub-menu and confirm with the ENTER
once to select the% FS sub-menu and confirm with the ENTER key. A dialogue
key closes the help window and all the dialogue boxes displayed.
A
Software
key. When active,
NTA47224-300A9 111 / 194