AOIP CALYS 150 Mode D'emploi page 113

During operation of the CALYS 150, several symbols are displayed to simplify selection and indication of the current
functions. These symbols are shown in the table below:
Symbol Description
Function keys
Tabulation key
Open a drop-down list
Close a drop-down list
Cancel the selected item
Stop the current transmission
Suspend the current transmission
Commence or resume transmission
Launch transmission in the increasing direction
Launch transmission in the decreasing direction
Transmit synthesised points in the order entered
Transmit synthesised points in the reverse order
Cancel the selection
Add the item being edited
Edit the selected item
Open a file
Indication symbols
Maintain transmission or display of measurements
Indication of battery state
HART compatibility is on
Loop power supply is on
Loop power supply is off
Square law scale is on
Warning: Out of Range or error
2 wire cabling detected
3 wire cabling detected
4 wire cabling detected
Transmission in incremental mode
Transmission in staircase mode
Transmission in simple ramp mode
Transmission in cyclic ramp mode
Transmission in synthesizer mode
Transmission in% of Full Scale mode (% FS)
Transmission in valve test mode
Item already selected
Measurement smoothing is active
The Tare function is on
Setting to scale is on
Pulse transmission
Acquisition in progress (the value to the right of the pictogram indicates the number of
values logged)
A
Software
NTA47224-300A9 113 / 194