A.4 Safety; Compliance With Safety Standards; Environnemental Conditions; Used Devices - AOIP CALYS 150 Mode D'emploi

CALYS 150

A.4 Safety

Compliance with safety standards

The unit complies with applicable standards:
- Safety directive 2006/95/CE with standard EN611010-1
- Directive CEM 2004/108/CE with standard EN61326-1
- Radio directive 1999/5/CE with standards EN300-328 and EN301-489
This user manual contains information and warnings which must be observed in order to protect the user against the hazards
of electric current, to ensure the safe operation of the device and to protect it against any mishandling which could damage
or compromise the safety of use of the device.

Environnemental conditions

As per publication EN 60359:
Range of application of standards: from 0 to 2,000 m.
Reference temperature range: 23°C ±5°C, relative humidity: 45% to 75%.
Nominal operating range: -10°C to +50°C, relative humidity: 20% to 80% non-condensing.
Operating range limit: -15°C to +55°C, relative humidity: 10% to 80% (70% at 55°C).
Storage and transport temperature range limit: -30°C to +60°C (without the batteries).

Used devices

Used electrical devices can pollute the environment. We recommend you refrain from disposing of this device in an ordinary
waste bin, but rather that you use the recycling circuits available locally. If not, you can return the device to us, and we will
take care of its disposal free of charge.
A.4.3.1 Waste generated by the device
List of waste classified according to the decree published:
16.02.14: Waste originating from electronic equipment:
Printed circuit boards making up the device
16.06.02: Batteries and storage battery (dangerous)
LiPo battery (Lithium Polymer 7.4 V)
Lithium 3V battery (type CR1225)
15.01.02: Packaging
ABS plastic and polycarbonate device casing
Elastomer conduit
A.4.3.2 Device destruction procedure
Open unit: unscrew screws from lower casing (after removing sheath).
Separate both shells and disconnect battery pack

Instructions

The unit is designed to be used in complete safety if the instructions given in the accompanying documents are followed.
Any use apart from those defined, may prejudice the safety of the operator and is therefore dangerous and forbidden.
114 / 194 NTA47224-300A9
GENERAL