Connection Terminals; Side Connectors - AOIP CALYS 150 Mode D'emploi

Connection terminals

Four terminals for the "measurement" function (IN) from channel 1 (V1) ; two of which are reserved for 3 or 4 wire connection
when measuring resistance, temperature with a resistive probe and current for a passive transmitter. Refer to paragraph
B.2.
Four terminals for connection when "transmit/simulate measurement" function (OUT/IN) from channel 2 (V2) is used. Refer
to paragraph
The 8 terminals of the CALYS 150 are of the "push & lock" type. They accept 4 mm banana plugs, bare wires, spade
terminals and miniature connectors for thermocouples.

Side connectors

There are two connectors on the left hand side of the unit:
One mains unit connector for battery charging.
One type B USB socket for connection to a computer.
Connectors dedicated to sensors (pressure and HART®) are located on the right-hand side of the unit.
Pressure sensor
socket
USB
Socket
Material
Charger
Socket
Hart sensor
connector
NTA47224-300A9
A
107 / 194