Fitting Accessories; Compressor; Sack Mangle - WAGNER PlastCoat PC15 Mode D'emploi

Plast Coat 15
EDITION 09 /2004
We recommend that you test the required texture on a sample
surface.
To improve the„feathering effect" in order to allow easier over-
lap, choose an appropriate distance between the spray lance
and the object surface.
The spray margin should„feather out" to allow easier overlap-
ping.
Considerably less spray mist is produced if the spray lance is
always guided at 90° parallel to the spray surface.
Note:
Sharp-edged grains and pigments will increase wear on the
pump, hose, material ball valve and tip.
9

FITTING ACCESSORIES

9.1

COMPRESSOR

V 400 suction volume 360 l/min
• Attach compressor holder (item 1, fig. 18) and secure with
star grip (2).
• Place compressor onto holder. Slide retainingplate (3) over
the compressor base.
• Secure the compressor with star grips (4).
18
C 350 suction volume 350 l/min
• Attach compressor holder (item 1, fig. 19) and secure with
star grip (2).
• Place compressor onto holder, attach retaining plate (3).
• Secure the compressor with star grips (4).
2
3
4
1
9.2

SACK MANGLE

Safety note
Danger of crushing
Do not pace hands under
the roller.
Technical data
Roller length: 465 mm
Roller diameter: 66 mm
Weight: 6.7 kg
Putting sack mangle into operation
• Connect crank handle (1, fig. 20) and secure with linch pin.
• Insert sack mangle and sliding cover (2, accessory).
• Screw out star grips (3) about 2 cm.
• Place sack mangle and crank handle (1) on the sliding cover
to the right from the front. Move guide rollers (4) over stop
pins on the underside of the sliding cover.
• Adjust pressure force of the roller (5). Turn the star grips (3)
to the right until they will go no further.
• Turn crank and move sack mangle to the rear as far as it will
go.
GB
FITTING ACCESSORIES
2
19
1
3
4
47