Control Unit; Equipment Overview; Symbols On The Changeover Switch; Drive - WAGNER PlastCoat PC15 Mode D'emploi

Plast Coat 15
EDITION 09 /2004
4.1

CONTROL UNIT

1 Master switch 0–1
2 Indicator lamp
3 Feed rate regulator 0–10
4 Changeover switch
5 Socket for stirrer, etc.
6 Mains cable
7 Connection for remote control
7
2
6
The mortar spraying machine can be switched on using
the master switch (1, fig. 3).
The indicator lamp (2) shows that the machine is ready for
operation.
The progressively adjustable feed rate regulator (3) is used to
adjust the feed rate from 0 –10.
4.1.1
SYMBOLS ON THE CHANGEOVER SWITCH (FIG. 4)
1 Releasing the pressure or removing the pump jacket.
Pump runs in reverse direction.
2 „0" drive is switched off.
3 „AUTO" remote control using the spray lance.
4 Spraying or pulling on the pump jacket. Pump runs in the
forwards direction.
3
1
3
4
1
5
4.2

DRIVE

If overloading occurs then the mortar spraying machine swit-
ches off.Turn master switch (1, fig.3) and changeover switch (4,
fig. 3) to„0". Wait at least 20 seconds and then turn the mortar
spraying machine back on.
4.3
RECEPTACLE (FIG. 5)
1 receptacle made of high-grade steel with grating. Contents:
60 liter
2 3
O AUTO.
GB

EQUIPMENT OVERVIEW

4
5
1
39