Adjust The Roof Profile; Set An Angle - probst LEVELFIX LF Instructions D'emploi

Adjustments
3.4

Adjust the roof profile

Following needs to be observed, when working with LF-170/310:
When the working width is 235 cm or less, additional clamping plates have to be used, so no material can
collect between the sheets. The usage of the clamping plates is described in the chapter „Adjust the
working width for LF-170/310".
3.4.1

Set an angle

To set the maximum angle the screeding bars (5) have to be extended approximately to the half.
1. Slightly release the ring nuts (4).
4
3. Slightly release the rear ring nut (6).
2. Adjust the screeding bars (5) to the desired
working width.
5
4. Adjust the desired angle by pulling the screeding
bars (5) by the middle ring nut (4) upwards.
6
4
5
11 / 18