Maintenance And Care; Maintenance; Mechanical; Service Interval - probst LEVELFIX LF Instructions D'emploi

Maintenance and care

5 Maintenance and care
5.1

Maintenance

To ensure the correct function, safety and service life of the device the following points must be executed in
the maintenance interval.
Used only original spare parts, otherwise the warranty expires.
All operations may only be made in closed state of the device!
5.1.1

Mechanical

SERVICE INTERVAL

First inspection after
25 operating hours
All 50 operating hours
Minimum 1x per year
(at rough conditions shorten the
interval)
5.2

Repairs

●
Only persons with the appropriate knowledge and ability are allowed to repair the device.
●
Before the device is used again, it has to be checked by an expert.
5.3

Hints to the type plate

Type, serial-number and production year are very important for the identification of your device. If you need
information to spare-parts, warranty or other specific details please refer to this information.
The maximum carrying capacity/working load limit (WLL) is the maximum load which can be handled with
the device. Do not exceed this carrying capacity/working load limit (WLL).
If you use the device in combination with other lifting equipment (Crane, chain hoist, forklift truck,
excavator) consider the deadweight of the device.
Maintenance work
●
Control and tighten all screws and connections.
(The implementation is only allowed by an expert).
●
Tighten all screws and connections (take care that the tightening torques according
to the property class of the screws are observed).
●
Check all existing safety elements (such as linchpins) for perfect function and replace
defective safety elements.
●
Check all joints, bolts, guidance's and gears for correct function, if necessary adjust or
replace it.
●
Grease all grease nipples (if available) with a grease gun.
●
Check of all the suspension parts, bolts and straps. Check for corrosion and safety by
an expert.
17 / 18