Publicité
Additional Programming
CONNECTIVITY (RECOMMENDED)
To connect the operator to a network, navigate to SYSTEM SETTINGS > CONNECTIVITY > LEARN > LEARN WIFI
submenu. See the "myQ® Smart Facility Access" section to connect your devices to myQ® Business Facility.
CONNECTIVITY
Hold ENTER and DOWN for three seconds to open the System Information Menu.
To learn remotes/transmitters navigate to SYSTEM SETTINGS > CONNECTIVITY > LEARN > SUBMENU. Once in learning
mode, press and release the desired button on the remote/transmitter to learn.
In Firmware 1.13 and newer, select RAPID LEARN to begin timed period to learn the same command (SBC/OPEN/
CLOSE/STOP) on multiple transmitters.
CONNECTIVITY
Note: RAPID LEARN available in Firmware 1.13 and newer
TRANSMITTER FREQUENCY
To switch transmitter frequency, navigate to SYSTEM SETTINGS > (Enter Passcode) >CONNECTIVITY > LEARN > RX
REQUENCY > (Select desired frequency) > Save > EXIT menu
LEARN
LEARNING
WIFI
WIFI
LEARN REMOTES
RAPID LEARN
SBC
OPEN
CLOSE
RAPID LEARN
SBC
OPEN
CLOSE
STOP
LEARN REMOTES
SBC
OPEN
CLOSE
STOP
42
Publicité
