Publicité
Additional Programming
ENTER PROGRAMMING
Simultaneously, press & hold the "Stop/Enter" and "Down" buttons for 3+ seconds to enter the operator menu. If the
controller is closed, press the "Stop" then "Close" then "Open" until the unit goes into program mode.
1.
Scroll down to "SYSTEMS SETTINGS" with the "UP" and "DOWN" buttons and press"Stop/Enter." You will be
prompted to enter the passcode for the operator.
2.
Enter 326 as the passcode.
DOOR
SELECT DOOR TYPE
SETTINGS
STANDARD LIFT
NOTE: Please obtain the latest Installation Manual by search the model number at liftmaster.com.
SELECT DOOR SETTINGS
FOR SECTIONAL DOORS ONLY
STANDARD, HIGH LIFT AND VERTICAL
1.
To select Door Hanging, Cable Drum (and Sprocket JHDC/ JDC) settings, navigate to the SYSTEM SETTINGS >
DOOR SETTINGS submenu.
2.
Select Drum Type. Correct Drum Type is required for optimizing door profile and system operation. Drum Type
options are based on user selection of Standard Lift, High Lift or Full Vertical Lift. (High Lift and Full Vertical Lift
are shown for JDC / JHDC only)
3.
Select Sprocket (for JDC / JHDC only). Select Custom to add a non-standard tooth-count.
FOR ROLLING DOORS ONLY
Select Rolling Door
1.
Select Insulated or Non-Insulated Door Type
2.
Select Height (increment of 2')
a.
8', 10', 12', 14', 16', 18', up to 28'
3.
Select Width (increment of 2')
a.
8', 10', 12', 14', 16', 18', up to 28'
4.
Select Sprocket (SKU dependent, please reference page 4)
a.
Sprocket choices: 50, 60, 72, 82, Custom
SET LIMITS
IMPORTANT: When first commissioning the limits, the operator's encoder is learning the positioning of the door for the
first time. As a result, the door must be moved a few seconds to allow for the encoder to begin tracking PRIOR to saving
the limits on the LCD wall control. For example, if the door is in the open position when first setting limits, move the door
down a few inches with the down arrow on the LCD wall control, then use the up arrow button to move the door back to
the fully open limit before hitting the stop button to save the open limit in the LCD wall control.
NOTE: Numeric values displayed when setting limits are encoder markers and not travel distance. Once set, the
encoder markers and travel distance can be confirmed under System Info menu.
To set limits, navigate to the SYSTEM SETTING > DOOR POSITIONS submenu.
DOOR
DOOR
POSITION
POSITION
OPEN LIMIT
MID-STOP
This operator allows for the programming of a single mid-stop door position.
1.
To set the open mid-stop position:
2.
In Programming Mode, go to Door Position => Open Mid-Stop or Close Mid-Stop.
3.
Use the Up/Down buttons to move the door to the desired position.
4.
Select Save = Enter
5.
To erase the mid-stop, select Erase Open Mid-Stop or Erase Close-Mid Stop option, then select Save=Enter.
NOTE: Restoring defaults or resetting limits will erase the mid-stop position.
CONNECTIVITY
SELECT DOOR TYPE
DOOR
POSITION
CLOSE
OPEN MID-
LIMIT
LEARN
RX REQUENCY
SELECT DOOR TYPE
HIGH LIFT
DOOR
DOOR
POSITION
POSITION
CLOSE MID-
STOP
STOP
40
SELECT DOOR TYPE
VERTICAL LIFT
DOOR
POSITION
RMV OPEN
MID
ROLLING
DOOR
POSITION
RMV CLOSED
MID
Publicité
