FAULT
Appliance cannot be switched on or
operated.
Appliance does not start.
Programme starts automatically.
Appliance stops during the pro-
gramme or cuts out.
All LEDs lit up or flashing.
Mechanical damage
FAULT
Appliance door cannot be closed.
Lid on the detergent dispenser can-
not be closed.
Noise
FAULT
Filling valves making knocking
noises.
CAUSE
Appliance functions have failed.
The mains fuse has tripped.
Mains cable is not inserted.
Appliance door is not closed prop-
erly.
You did not wait until programme
ended.
Appliance door is not closed prop-
erly.
Power and/or water supply has
been interrupted.
Top basket is pressing against in-
ner door and preventing appliance
door from being closed securely.
Electronics have detected a fault.
CAUSE
Door lock has been activated.
Door cannot be closed due to in-
stallation method.
Detergent dispenser or lid are
blocked by sticky detergent
residue.
CAUSE
Caused by the domestic installa-
tion. No appliance fault present.
Does not affect functioning of the
appliance.
TROUBLESHOOTING
Pull out the mains plug or switch off the fuse.
1.
Wait at least 2 minutes.
2.
Connect the appliance to the power supply.
3.
Switch the appliance on.
4.
Check the relevant fuse.
●
Check whether the socket works.
1.
Check whether the mains cable is properly in-
2.
serted in the socket and on the rear of the
appliance.
Close the appliance door.
●
→ "Terminate programme", Page 24
●
Close the appliance door.
●
Check the power supply.
1.
Check the water supply.
2.
Check whether the rear panel of the appli-
●
ance is being pressed in by a socket or hose
holder that has not been removed.
Arrange the tableware so that no parts pro-
●
ject beyond the basket and prevent the appli-
ance door from closing properly.
Press the main switch button for approx.
1.
4 seconds.
The appliance is reset and restarted.
If the problem occurs again:
2.
Switch off the appliance.
●
Pull out the mains plug or switch off the
●
fuse in the fuse box.
Wait at least 2 minutes.
●
Switch on the fuse in the fuse box or in-
●
sert the mains plug.
Switch the appliance on.
●
If the problem occurs again:
3.
Contact customer service.
●
TROUBLESHOOTING
Close the appliance door with greater force.
●
Check whether the appliance has been in-
●
stalled properly.
When closed, the appliance door, its decor or
attached parts should not knock against adja-
cent cabinets or the worktop.
Remove detergent residue.
●
TROUBLESHOOTING
Can only be remedied in the domestic install-
●
ation.
35