IKEA KALLBODA Mode D'emploi page 29

Troubleshooting
Troubleshooting
You can rectify minor faults on your appliance yourself. Read the troubleshooting information before contacting after-sales
Troubleshooting
service. This will avoid unnecessary costs.
WARNING
Risk of electric shock!
Incorrect repairs are dangerous.
●
Repairs to the appliance should only be carried out by trained specialist staff.
●
Only use genuine spare parts when repairing the appliance.
●
If the power cord or the appliance power cable of this appliance is damaged, it must be replaced with a special power cord
●
or special appliance power cable, which is available from the manufacturer or its Customer Service.
Error code / Fault display / Signal
FAULT
E:20-60 lights up alternately.
E:21-30 will light up alternately.
E:30-00 will light up alternately.
E:31-00 will light up alternately.
E:32-00 will light up alternately or
indicator for water supply lights up.
E:34-00 will light up alternately.
1
Depending on the appliance specifications
CAUSE
Appliance has detected calcified
heating element.
Intake opening for drying is
covered by items of tableware.
Water protection system is activ-
ated.
Water protection system is activ-
ated.
Supply hose is kinked.
Water tap is turned off.
Water tap is jammed or furred up.
The filters in the water connection
of the supply or AquaStop hose are
blocked.
Water is continuously running into
the appliance.
TROUBLESHOOTING
Descale the appliance.
1.
Operate the appliance with the "water soften-
2.
ing system" → Page 19.
Re-arrange the tableware in the appliance so
●
the "intake opening for drying" → Page 12 is
no longer obstructed.
Turn off the water tap.
1.
Call Customer Service.
2.
Turn off the water tap.
1.
Call Customer Service.
2.
Install the supply hose without kinks.
●
Turn on the water tap.
●
Turn on the water tap.
●
The flow rate must be at least 10 l/min when
the water supply is open.
Switch off the appliance.
1.
Pull out the mains plug.
2.
Turn off the water tap.
3.
Unscrew the water connection.
4.
Remove the filter from the supply hose
5.
Clean the filter.
6.
Re-insert the filter in the supply hose.
7.
Screw the water connection back on.
8.
Check the water connection for leaks.
9.
Restore the power supply.
10.
Switch the appliance on.
11.
Turn off the water tap.
1.
Call Customer Service.
2.
29
1