IKEA KALLBODA Mode D'emploi page 32

ENGLISH
FAULT
Detergent residue in the appliance
Water marks on plastic parts.
Wipeable or water-soluble coatings
are present inside the appliance or
on the door.
Stubborn white coatings are
present on tableware, inside the
appliance or the door.
Tea residue or lipstick marks on
tableware.
CAUSE
The lid of the detergent dispenser
is blocked by the tab and will not
open.
Tabs are used in the quick or short
programme. Dissolving time of the
tab is not attained.
Washing effect and dissolving per-
formance are reduced after a pro-
longed storage time or detergent is
very lumpy.
Due to laws of physics droplet
formation on plastic surfaces is un-
avoidable. After drying water marks
are visible.
Detergent substances are depos-
ited there. These coatings cannot
generally be removed with chemic-
als.
White coating is deposited in the
appliance interior.
Special salt dispenser is not
screwed tight.
Detergent substances are depos-
ited there. These coatings cannot
generally be removed with chemic-
als.
Hardness range is set incorrectly or
the water hardness is too high.
→ "Overview of water hardness set-
tings", Page 19
3in1/organic/eco detergent is not
effective enough.
Too little detergent is being used.
Washing programme selected too
weak.
Washing temperature is too low.
Too little detergent is being used or
is unsuitable.
Tableware has been precleaned too
intensely. The sensors chose a
weaker programme. Stubborn soil-
ing cannot be entirely removed.
TROUBLESHOOTING
Position the tab in the detergent dispenser
●
crosswise, not vertically.
Select a more intensive "Programme"
●
→ Page 15 or use "Powder detergent"
→ Page 21.
Change your detergent.
●
Select a more intensive programme.
●
→ "Overview of programmes", Page 15
Position tableware at an angle.
●
→ "Arrange tableware", Page 23
Use rinse aid.
●
→ "Rinse aid", Page 20
Set the water softening system higher.
●
→ "Setting the water softening system", Page 19
Change your "detergent" → Page 21.
●
Clean the appliance mechanically.
●
Set the water softening system correctly.
1.
→ "Setting the water softening system", Page 19
In most cases you will need to increase the
setting.
Change your detergent if required.
2.
Screw the special salt dispenser tight.
●
Change your "detergent" → Page 21.
●
Clean the appliance mechanically.
●
Set the Water softening system to the water
●
hardness or add special salt.
Set the Water softening system to the water
●
hardness and use separate detergents (pro-
prietary detergent, special salt, rinse aid).
Increase the amount of detergent used or
●
change "Detergent " → Page 21.
Select a more intensive washing programme.
●
→ "Overview of programmes", Page 15
Adjust the sensitivity of the sensors.
●
→ "Sensors", Page 10
Select a programme with a higher washing
●
temperature.
→ "Overview of programmes", Page 15
Use a suitable "Detergent " → Page 21 and fol-
●
low the manufacturer's instructions for the
amount to be used.
Only remove large remnants of food and do
●
not prerinse tableware.
Adjust the sensitivity of the sensors.
●
→ "Sensors", Page 10
32