IKEA KALLBODA Mode D'emploi page 31

FAULT
Tableware is not dry.
Plastic tableware is not dry.
Cutlery is not dry.
Appliance interior still wet after
wash cycle.
Remnants of food on tableware.
Detergent residue in the appliance
CAUSE
Extra Dry not activated to improve
drying performance.
Tableware removed too early or
drying process not yet ended.
Rinse aid used has a limited drying
performance.
Not a fault. As plastic does not
store heat so well, it also does not
dry as well.
Cutlery not arranged properly in
the cutlery basket or cutlery
drawer.
Not a fault. The condensation dry-
ing principle causes water droplets
in the tub – they are indeed desir-
able here. The moisture in the air
condenses on the inside walls, runs
off and is pumped out.
Tableware is placed too close to-
gether or basket is overfilled.
Spray arm rotation of the lower
spray arm is blocked.
Spray arm nozzles are blocked.
Filters are soiled.
Filters are inserted incorrectly and/
or not engaged.
Washing programme selected too
weak.
Tableware has been precleaned too
intensely. The sensors chose a
weaker programme. Stubborn soil-
ing cannot be entirely removed.
Tall narrow receptacles in corner
areas are not rinsed adequately.
Top baskets on right and left are
not set to same height.
Lid of the detergent dispenser is
blocked by items of tableware parts
and will not open.
TROUBLESHOOTING
Use a different combined detergent with a
2.
better drying performance.
Activate Extra Dry.
●
Wait until the programme ends.
1.
Only remove tableware 30 minutes after the
2.
programme has ended.
Use a name-brand rinse aid.
●
Eco products may have limited effectiveness.
No remedial action possible.
●
Droplets can form on the cutlery contact points.
"Arrange cutlery individually where possible."
1.
→ Page 23
Avoid points of contact.
2.
No action required.
Arrange tableware with sufficient space in
1.
between.
The spray jets must reach the surfaces of the
tableware.
Avoid points of contact.
2.
Arrange tableware so that it does not ob-
●
struct spray arm rotation.
Clean the "Spray arms" → Page 28.
●
Clean the filters.
●
→ "Cleaning filters", Page 27
Insert the filters properly.
1.
→ "Filter system", Page 27
Engage the filters.
2.
Select a more intensive washing programme.
●
→ "Overview of programmes", Page 15
Adjust the sensitivity of the sensors.
●
→ "Sensors", Page 10
Only remove large remnants of food and do
●
not prerinse tableware.
Adjust the sensitivity of the sensors.
●
→ "Sensors", Page 10
Do not position tall narrow receptacles at too
●
great an angle or in corner areas.
Set the upper basket on the left and right to
●
the same height.
→ "Top basket", Page 16
Arrange tableware in the top basket table-
1.
ware so the tab collecting tray is not obstruc-
ted by tableware.
→ "Arrange tableware", Page 23
Items of tableware are blocking the dispenser
lid.
Do not place tableware or fragrance dis-
2.
pensers in the tablet collecting tray.
31