IKEA KALLBODA Mode D'emploi page 19

ENGLISH
Basket heights
Set the baskets at the right height.
Appliance height 86.5 cm with cutlery drawer
LEVEL
1 max. ø
2 max. ø
3 max. ø
Before first use
Before first use
Before first use
Performing the initial configuration
On initial start-up or after a reset to the factory settings, you
will need to make settings.
Requirement: "The appliance has been installed and con-
nected." → Page 10
"Add special salt." → Page 20
1.
"Add rinse aid." → Page 20
2.
"Switch on the appliance." → Page 24
3.
Water softening system
Water softening system
Hard water leaves limescale on the tableware as well as the
Water softening system
washing tank, and parts of the appliance may become
blocked.
To ensure good dishwashing results, you can treat the water
with special salt and the water softening system. To avoid
damage to the appliance, water with a hardness above 9 °E
must be softened.
Overview of water hardness settings
You can find an overview of the water hardness values that can be selected here.
You can find out how hard your water is from your local water company or by using a water hardness tester.
WATER HARDNESS °E
0 - 8
9 - 10
11 - 12
13 - 15
16 - 20
21 - 26
27 - 38
39 - 62
Note: Set the water hardness determined on your appliance.
→ "Setting the water softening system", Page 19
With a water hardness of 0 - 8 °E you can dispense with spe-
cial salt for dishwashers and switch off the water softening
system.
→ "Switching off the water softening system", Page 20
Setting the water softening system
Set the water hardness on your appliance.
Determine the water hardness and the appropriate set-
1.
ting value.
→ "Overview of water hardness settings", Page 19
TOP BASKET
18 cm
20.5 cm
23 cm
HARDNESS RANGE
Soft
Soft
Medium
Medium
Medium
Hard
Hard
Hard
BOTTOM BASKET
33 cm/"34 cm" → Page 17
30.5 cm
28 cm
"Setting the water softening system." → Page 19
4.
"Set the amount of rinse aid to be dispensed." → Page 21
5.
"Add detergent" → Page 21.
6.
Start the Programme with the highest cleaning temperat-
7.
ure without tableware.
To remove any marks from water or other residues, we
recommend you operate the appliance without tableware
before using it for the first time.
Tip: You can change these settings and other Basic settings
at any time.
MMOL/L
0 - 1.1
1.2 - 1.4
1.5 - 1.8
1.9 - 2.1
2.2 - 2.9
3.0 - 3.7
3.8 - 5.4
5.5 - 8.9
Press ⁠ .
2.
To open the basic settings, press
3.
seconds.
The display shows H:xx.
a
The display shows
a
Press or repeatedly until the right water hardness
4.
has been set.
The value H:04 is set at the factory.
To save the settings, press
5.
SETTING VALUE
H:00
H:01
H:02
H:03
H:04
H:05
H:06
H:07
for 3
⁠ .
for 3 seconds.
19