IKEA KALLBODA Mode D'emploi page 34

ENGLISH
FAULT
Irreversible clouding of glassware.
Rust spots on cutlery.
Detergent residue is present in the
detergent dispenser or the tablet
collecting tray.
Excessive formation of foam oc-
curs.
Information on display panel
FAULT
Special salt refill indicator lights up. Insufficient special salt.
Refill indicator for special salt does
not light up.
Refill indicator for rinse aid lights
up.
Refill indicator for rinse aid does
not light up.
Malfunctions
FAULT
Water is left in the appliance at the
end of the programme.
CAUSE
Glasses are not dishwasher-proof,
only suitable for dishwashers.
Cutlery is not sufficiently rust-res-
istant. Knife blades are often more
severely affected.
Cutlery may also rust if washed to-
gether with rusting items.
Salt content in washing water is too
high.
Spray arms were blocked by table-
ware so detergent was not rinsed
out.
Detergent dispenser was damp
when detergent was added.
Hand washing-up liquid is present
in dispenser for rinse aid.
Rinse aid has been spilled.
Detergent or appliance care
product used causes excessive
foaming.
CAUSE
Sensor does not detect special salt
tablets.
Water softening system is switched
off.
Insufficient rinse aid.
Rinse aid system is switched off.
CAUSE
Filter system or area under the fil-
ters is blocked.
Programme has not yet ended.
TROUBLESHOOTING
Use dishwasher-proof glasses.
●
Glasses are usually only suitable for use in a
dishwasher, i.e. long-term wear or long-term
changes must be expected.
Avoid a lengthy steam phase (standing time
●
after wash cycle ends).
Use a programme with a lower temperature.
●
→ "Overview of programmes", Page 15
Set the softening system to the water hard-
●
ness.
→ "Setting the water softening system", Page 19
Use detergent with a glass protection com-
●
ponent.
Use rust-resistant tableware.
●
Do not wash rusting items.
●
Remove any spilled special salt from the tub.
1.
Screw the cap of the special salt dispenser on
2.
tight.
Check that the spray arms are not blocked
●
and can rotate freely.
Only add detergent to a detergent dispenser
●
when dry.
Immediately add rinse aid to the dispenser.
●
→ "Adding rinse aid", Page 20
Remove the rinse aid with a cloth.
●
Change the brand of detergent.
●
TROUBLESHOOTING
Add "Special salt" → Page 20.
●
Do not use special salt tablets.
●
Set the water softening system.
●
→ "Setting the water softening system", Page 19
Add "Rinse aid" → Page 20.
1.
Set the amount of rinse aid to be dispensed.
2.
→ "Setting the amount of rinse aid", Page 21
Set the amount of rinse aid to be dispensed.
●
→ "Setting the amount of rinse aid", Page 21
TROUBLESHOOTING
Clean the "Filters" → Page 27.
1.
Clean the "Wastewater pump" → Page 37.
2.
Wait until the programme ends or cancel the
●
programme with Reset.
→ "Terminate programme", Page 24
●
34