2. A top view of a motorhome (bird's eye perspective) with a bull's
eye level is displayed.
The bubble is shown as a green point. The controls are positi-
oned on the vehicle's main sides (front, rear, left, right) as four
blue points.
If one of the four points (c) is touched, the full control appears.
You level the vehicle by manoeuvring the bubble into the centre
of the bull's eye level.
In addition, it is possible to control the system at two different
speeds (d), which means that fast movements into the opera-
ting area are possible, as well as precise movements within the
operating area itself.
Please note the following sequence in order to achieve a low entry height (similar to the automatic
process):
Alignment in a longitudinal direction: lift the lower side of the vehicle (front/back) until the bubble
is located level with the centre, i.e. on an imaginary horizontal axis running through the centre.
Alignment in a transverse direction: raise the lower side of the vehicle (left, right) until the bubble
is in the centre.
As the bubble gets closer to the centre, the screen zooms in, making it easier to fine-tune the
position in the final stage.
It is always indicated whether the supports are fully retracted or not as information for the user.
If one of the supports is partially extended, the „Legs out" icon is displayed.
4102561_b
en
93