Publicité
5. First, extend the front cylinder pair by sliding the switch (a)
„Front". The system automatically detects ground contact, stops
for a short time and then continues with reduced extension
speed after reactivation.
Stop the extension movement upon ground contact.
6. Then extend the rear cylinder pair by sliding the switch (b)
„Rear". The system automatically detects ground contact, stops
for a short time and then continues with reduced extension
speed after reactivation.
Stop the extension movement upon ground contact.
7. Place two spirit levels on the vehicle floor (inside), transverse
to the driving direction and in the driving direction. These serve
as a reference.
8. Continue to extend the vehicle's supports until the bubbles of
both spirit levels are exactly in the middle between the limits. If
you have raised the vehicle too much overall, this is not crucial
for the subsequent levelling process; information on angle and
not height is saved.
However, if you have reached the end of a cylinder wit-
hout the vehicle being horizontally aligned, it must first be
checked that the cylinder is in the correct position.
Ensure that the cylinder has been installed at the specified
height (guide value 160-190 mm ground clearance) and
that the vehicle is located on a level ground.
Fully retract all cylinders and repeat steps 3-6.
4102561_b
en
83
Publicité
