Publicité
en
TRANSFER AND DISPOSAL
The system has been fitted to your specific vehicle. If it is to be transferred to another base vehicle
or removed, this can be done by a trained E&P service partner. In doing so, it must be ensured that
it is properly dismantled and that the connection points on the base vehicle are carefully preserved.
To this end, the specifications in the base vehicle bodywork guideline must be observed.
The hydraulic oil used is not biodegradable. All of it must be collected and disposed of at a waste
management company specialised in the disposal of media.
Hydraulic lines installed in one instance must not be used further and must be disposed of.
Electronic components, suchas the TCU manual operating device, controller, motor driver, and BLDC
motors must be disposed of separately as electrical scrap. The TCU manual operating device contains
a 1,600 mAh battery; this can be disposed of at a waste centre or local collection centre.
4102561_b
103
Publicité
