2. A top view of a motorhome (bird's eye perspective) with a bull's
eye level is displayed.
The bubble is shown as a green point. The controls are positi-
oned on the vehicle's main sides (front, rear, left, right) as four
blue points.
If one of the four points (a) is touched, the full control appears.
In order to avoid any harmful impacts on the vehicle or chassis,
e.g. torsion, the cylinder movement is limited to the extension
direction; i.e. you can level the vehicle by gradually extending
the cylinders/pairs of cylinders.
For retraction, all supports are activated together at the same
time (b).
Once all supports have been retracted, the „Legs out" icon is no
longer visible on the TCU.
You level the vehicle by manoeuvring the bubble into the centre
of the bull's eye level.
Please note the following sequence in order to achieve a low entry height (similar to the automatic
process):
Alignment in a longitudinal direction: lift the lower side of the vehicle (front/back) until the bubble
is located level with the centre, i.e. on an imaginary horizontal axis running through the centre.
Alignment in a transverse direction: raise the lower side of the vehicle (left, right) until the bubble
is in the centre.
As the bubble gets closer to the centre, the screen zooms in, making it easier to fine-tune
the position in the final stage.
The system stops automatically when the levelled position has been reached, i.e. as soon as the
bubble is in the centre. By re-activating the controls, this position can be manually exceeded, which
enables the vehicle to be moved into positions beyond a levelled state.
It is always indicated whether the supports are fully retracted or not as information for the user.
If one of the supports is partially extended, the „Legs out" icon is displayed.
4102561_b
en
91