Use As A Blower - Efco AT 900 Manuel D'utilisation Et D'entretien

of the weight of the machine, the weight of the
mixture when the tank is full and that of the
chemical product.
GB
WARNING - Close firmly the cap of the
liquid tank to retain the pressure flow in the tank
from the plastic tube, attached on the cap. The
pressure allows the liquid to come out even when
the throwing pipe is in vertical position.
HOW TO PUT THE MIST BLOWER ON YOUR
SHOULDERS
Wear the mist blower on your shoulders using the
following procedure:
· Lift the mist blower with the left hand by
the shoulder straps (never lift it by the liquid
tank, the cover of the engine or the frame) by
positioning the right shoulder strap on the
right shoulder.
· Insert the left arm under the left shoulder strap
in order to position it on your shoulder.
· Set the length of the shoulder straps referring
to the procedure "Adjusting of the shoulder
straps".
TREATMENT
Please read carefully the chapter "Safety
precautions" which will indicate you all the
precautions required for mist blower using.
· The throwing pipe has to be addressed toward
the crops that must be treated, and never
against the wind.
· While spraying, regulate the engine revolutions
depending on your needs; it is not always
necessary working at maximum power.
Using the wide spray jet, the exit is widened to
cover a greater area:
· Use with the spray jet – Widened range.
· Use with only the spreader – Narrower but
longer range.
How to address the throwing pipe to optimize
treatments:
· Elliptical rotation from right to left-hand side
= open field.
· 'U' rotation = plants, espalier cultivations and
walls for disinfection.
30
How to obtain a correct micronization of the
product:
1. By the regulation of the liquid flow thanks to
the graduated regulator (B, Fig.4) from 1 (less
flow) to + (maximum flow). The bigger is the
quantity of liquid, the greater will result the
dimension of the drop.
2. By the regulation of the revolutions of the
engine. The bigger is the quantity of air, the
smaller will result the dimension of the drop.

USE AS A BLOWER

Your mist blower can be used as a blower for
cleaning purpose.
· Always open throttle lever gradually until
engine reaches the proper revolution before
starting blowing.
· Blowing regulate engine revolution depending
on your needs, maybe it is not necessary to run
the engine at maximum revolution..
· You can use the wide blow outlet as standard.
Use the small outlet if you need more air
power, for example for blowing on a wet
ground.
WARNING - Pay always attention to any
possible objects that can be present in the area
you are going to clean (pieces of broken glass,
stones, etc.). These objects could be "thrown" by
blowing.