Publicité
Les langues disponibles
Les langues disponibles
Before contacting service, check the following to avoid unnecessary service charges.
Oven Problem
Error F1030* or F2030* appears in the display window.
Other F__ Error appears in the display window.
The oven display stays OFF
Cooling fan continues to run after oven is turned off
Oven door is locked and will not release, even after cooling
Oven is not heating
Oven is not cooking evenly
Oven light is not working properly
Oven light stays on
Oven will not Self-Clean properly
Clock and timer are not working properly
Excessive moisture
Porcelain chips
22 - Solving Operational Problems
Problem Solving Steps
A problem with latch mechanism occurred. Remove power and turn it
back on again after a few seconds. The oven should run a latch auto–
test. If condition persists, note the code number (in the EVENT LOG list)
and contact service.
Remove power and turn it back on again after a few seconds. If
condition persists, note the code number (in the EVENT LOG list) and
contact service.
Turn off power at the main power supply (fuse or breaker box). Turn
breaker back on.
If condition persists, call an authorized service.
The fan turns off automatically when the electronic components have
cooled sufficiently.
Turn the oven off at the circuit breaker and wait a few seconds. Turn
breaker back on.
The oven should reset itself and will be operable.
Check the circuit breaker or fuse box to your house. Make sure there is
proper electrical power to the oven. Make sure the oven temperature
has been selected.
Refer to cooking charts for recommended rack position. Always reduce
recipe temperature by 25°F (15°C) when baking with Convection
Bake mode.
Replace or reinsert the light bulb if loose or defective. See Page 33.
Avoid touching the bulb glass with bare fingers as finger oil may cause
bulbs to burn out prematurely.
Check for obstruction in oven door. Check to see if hinge is bent or door
switch broken.
Allow the oven to cool before running Self-Clean. Always wipe out
loose soils or heavy spill-over before running Self-Clean. If oven is
badly soiled, set oven for a four-hour Self-Clean. See Preparing the
Oven to Self-Clean, Page 31.
Make sure there is proper electrical power to the oven. See the Clock
sections on Page12.
When using Bake mode, preheat the oven first. Convection Bake and
Convection Roast will eliminate any moisture in oven (this is one of the
advantages of convection).
When oven racks are removed and replaced, always tilt racks upward
and do not force them to avoid chipping the porcelain.
EN
35
Publicité
