Publicité
Les langues disponibles
Les langues disponibles
20 - Oven Door
EN
Automatic door locking during pyrolytic
cycle
For safety reasons, the door is locked automatically as soon as self-
clean mode is selected (both standard, both eco clean). The door
is also unlocked automatically when the clean time has expired but
only after the temperature has fallen below the safety threshold.
NOTE
It is not possible to exclude the door locking device during
self-cleaning i.e. manually unlock the door since the self-
cleaning mode has the highest priority and overrides all
other selections.
The lock symbol (
) on the display is:
ON
When the door is fully locked
OFF
When the door is fully unlocked
FLASHING
When the latch mechanism is moving or is waiting
for a command by the electronic control. (After self
clean the symbol will flash until the temperature will
be safe and the door unlocked).
Removing the "FULL GLASS" panoramic
door
WARNING
Make sure that:
• The oven is cool and power to the oven has been turned off before
removing the door. Failure to do so could result in electrical shock or burns.
• The oven door is heavy and fragile. Use both hands to remove the oven
door. The door front is glass. Handle care-fully to avoid breakage.
• Grasp only the sides of the oven door. Do not grasp the handle as it may
swing in your hand and cause damage or injury.
• Failure to grasp the oven door firmly and properly could result in personal
injury or product damage.
Removing the oven door
The oven door can be removed quickly and easily. To do so,
proceed as follows:
• Open the door fully.
• Lift the two levers shown below.
• Close the door as far as the first stop (caused by the raised levers).
• Lift the door upwards and outwards to remove it fromits mountings.
To replace fit the door, fit the hinges in their mountings and lower
the two levers
32
How to remove the inner glass of the "FULL
GLASS" panoramic door
1. Wear protective gloves.
2. Place the door on a flat horizontal surface face down on a soft
cloth to avoid scratching the visible part.
3. Remove the two lateral caps and pull out the top strip.
Publicité
