Johnson Controls 3G4010CF Manuel D'installation page 39

If trouble is experienced with this equipment for repair or warranty information, please contact
the facility indicated below. If the equipment is causing harm to the telephone network, the
Telephone Company may request that you disconnect the equipment until the problem is solved.
This equipment is of a type that is not intended to be repaired by the end user.
DSC c/o APL Logistics, 2600 West Pointe Dr.., Lithia Springs, GA 30122
Additional Information
Connection to party line service is subject to state tariffs. Contact the state public utility
commission, public service commission or corporation commission for information. Alarm dialling
equipment must be able to seize the telephone line and place a call in an emergency situation. It
must be able to do this even if other equipment (telephone, answering system, computer modem,
etc.) already has the telephone line in use. To do so, alarm dialling equipment must be connected
to a properly installed RJ-31X jack that is electrically in series with and ahead of all other equipment
attached to the same telephone line. Proper installation is depicted in the figure below. If you have
any questions concerning these instructions, you should consult your telephone company or a
qualified installer about installing the RJ-31X jack and alarm dialling equipment for you.
Figure 7: Customer premises equipment and wiring
Industry Canada Compliance Statement
This Equipment meets the applicable Industrial, Scientific and Economic Development (ISED)
Terminal Equipment Technical Specifications. This is confirmed by the registration number. The
abbreviation, IC, before the registration number signifies that registration was performed based
on a Declaration of Conformity indicating that ISED Canada technical specifications were met. It
does not imply that that ISED Canada approved the equipment. The Ringer Equivalence Number
(REN) for this terminal equipment is 0.0. The REN assigned to each terminal equipment provides an
indication of the maximum number of terminals allowed to be connected to a telephone interface.
The termination on an interface may consist of any combination of devices subject only to the
requirement that the sum of the Ringer Equivalence Numbers of all devices does not exceed 5.
IC:160A-3G4010CF
IC:160A-LE4010CF
This Class B digital apparatus meets all requirements of the Canadian interferencecausing
equipment regulations.
CAN ICES-3 (B) / NMB-3 (B)
The term "IC:" before the radio certification number only signifies that ISED Canada technical
specifications were met.
NIST Validation of encryption algorithm AES128 certificate No. xxxx
Warranty
Limited Warranty
Digital Security Controls ("DSC"), a division of Tyco Safety Products Canada Ltd, a part of the
Johnson Controls group of companies ("JCI"), warrants the original purchaser that for a period
of twelve months from the date of purchase, the product shall be free of defects in materials and
workmanship under normal use. During the warranty period, JCI shall, at its option, repair or
replace any defective product upon return of the product to its factory, at no charge for labour
and materials. Any replacement or repaired parts are warranted for the remainder of the original
warranty or ninety (90) days, whichever is longer. The original purchaser must promptly notify JCI
in writing that there is defect in material or workmanship, such written notice to be received in all
events prior to expiration of the warranty period. There is absolutely no warranty on software and
3G4010CF / LE4010CF Installation manual
39