Publicité
Les langues disponibles
Les langues disponibles
When the 3G4010CF/LE4010CF sends a request to communicate with the central station, the top
signal strength LED begins flashing.
Red
ON
When the central station responds to the 3G4010CF/LE4010CF , the top signal strength LED turns on
solid.
Red
ON
When the 3G4010CF/LE4010CF sends a request to communicate with the next central station, the
bottom signal strength LED begins flashing.
Red
ON
When a signal is received from the central station, the bottom signal strength LED turns on solid.
Red
ON
If at least one of the central stations did not respond to the communicator, the signal strength LED
corresponding to that central station turns off. Once the initialization sequence completes, the
3G4010CF/LE4010CF begins steady state operation.
Step 6 - Mount the 3G4010CF/ LE4010CF
Note: Check for cable conduits and water pipes before drilling.
Note: Ensure that power and Telco circuit connections are made only after the cabinet
has been secured to the building or structure, and has been connected to the protective
earth ground. Descriptions of the terminals can be found in the 'Connecting the 3G4010CF/
LE4010CF' section.
Note: Please refer to the end of this manual for wiring diagrams.
1. Power down the 3G4010CF/LE4010CF by removing the DC power source and battery leads.
2. Using the cabinet, mark the four screw locations. Drill the anchor screw holes.
3. Using anchor screws (not provided), mount the cabinet to the wall.
4. Run the cables through the cable entry [13] or through the cabinet knockouts.
5. Complete the connections on the terminal blocks [11].
6. Reattach the front cover [1] securely to the cabinet.
3G4010CF / LE4010CF Installation manual
Blue
ON
Blue
ON
Blue
ON
Blue
ON
Yellow / Green (high)
FLASHING
Yellow / Green (high)
ON
Yellow / Green (high)
ON
Yellow / Green (high)
ON
Yellow / Green (low)
OFF
Yellow / Green (low)
OFF
Yellow / Green (low)
FLASHING
Yellow / Green (low)
ON
15
Publicité
