Johnson Controls 3G4010CF Manuel D'installation page 22

Table 6: 3G4010CF/LE4010CF reporting codes
Reporting codes CID
Periodic Test E603 XXX
Periodic Test with E608 XXX
Trouble
Radio Activation R552 000
Internal Buffer E624 000
Full
FTC Restoral R354 000
Firmware Update R901 000
Successful
Firmware Update E902 000
Fail
Firmware Update E901 000
Begin
System Tamper E145 000
System Tamper R145 000
Restore
* C24 Communications default value
Swinger shutdown - only used on model LE4010CF
To prevent "runaway" signals to the central station, the 3G4010CF/LE4010CF is equipped with
Swinger Shutdown which limits certain trouble events to a maximum of four reports every 24
hours. The condition restores and the counter resets at midnight. A zone input must be physically
restored when swinger shutdown is cleared before the alarm restore reporting code is transmitted
to the central station. Otherwise, the zone input is remains in an 'off normal' state. Swinger
Shutdown applies to the following trouble conditions:
• System Tamper/Restore
• Low Battery Trouble/Restore
• TLM Trouble/Restore
• Input Power Trouble/Restore
• FTC Restore
Swinger shutdown for zone inputs (Software Version 5.12+) - only used on
model LE4010CF
Depending on the reporting codes programmed by Connect 24, swinger shutdown may not be
applied. Reporting codes associated with Fire, Fire Supervisory or Panic/Holdup will not have
swinger shutdown applied to the Zone 1 to Zone 4 inputs when programmed
SIA Programmable
RP XXX FIXED
RY XXX FIXED
RS 000 FIXED
JL 000 FIXED
YK 000 FIXED
LS 000 FIXED
LU 000 FIXED
LB 000 FIXED
ES 000 FIXED
EJ 000 FIXED
Comments
Test Transmission
<Receiver Path>
Test Transmission
<Receiver Path>
Remote
Programming
Successful
Communications
Restored
Case Tamper
Case Tamper
Restore
3G4010CF / LE4010CF Installation manual
22