Publicité
Les langues disponibles
Les langues disponibles
Note: The 3G4010CF/LE4010CF will not process remote firmware update requests while the
following troubles are present.
•
Input Power Trouble
•
Low Battery Trouble
Low power radio shutdown
When the battery voltage reaches the low battery threshold of 10.5V, the unit turns off the radio
to prevent unnecessary network registrations. In this state, the unit does not communicate any
events.
Radio shutdown is indicated by the LEDs as follows:
•
Red LED indicates low battery trouble.
•
Two green LEDs blinking on/off together indicates the radio is not ready.
This LED sequence is displayed until the low battery voltage is restored and the radio is enabled
again.
Phone number call direction
The PTM phone numbers to receiver group 1 or 2 are programmable. The number programmed
in the communicator must also be programmed as the panel phone number. When the
communicator detects the phone number, it communicates to the receivers of the corresponding
group.
Note: If no PTM phone number is programmed, all panel calls go to Receiver Group 1.
3G4010CF / LE4010CF Installation manual
24
Publicité
